Printed Decal Application

application-mb2-01.jpg

Step 1:  Clean your band and apply some heat.  Please check this page for tips on cleaning your MagicBand, and applying some heat to aid in application and ensure the best adhesion possible.

 

application-mb2-02.jpg

Step 2:  Peel one half decal piece from the backing paper, and begin applying your decal in the center of your MagicBand 2.0, directly adjacent to the opening where the Disney Icon disc is located.  Leave those side pieces loose for now while you position the decal on the band.

 

application-mb2-03.jpg

Step 3:  Pull gently but firmly downward, centering your decal as you go.  Your vinyl is flexible and a bit stretchy, but take care not to stretch too much or the tail of your decal will extend beyond the end of the MagicBand.  Rub rub rub firmly all over the decal to ensure proper adhesion.

 

application-mb2-04.jpg

Step 4:  Now that the main portion of the decal is in place, you can position those center pieces.  Slide your thumb around the curve of the Icon opening to position each side.  You can carefully lift these ends and reposition if you don’t get it quite right the first time.

 

 

application-mb2-05.jpg

Step 5:  Repeat steps 1 through 4 to apply the second half of your decal.  The tail end pieces will overlap a few millimeters to give the illusion of a one-piece decal.

 

application-mb2-06.jpg